Sosmetal Products, Inc. 2026 Product Catalog

SOSMETAL PRODUCTS INC.

CONNECTORS ELECTRICAL FASTENERS

IN-LINE BUTT CONNECTORS Joins two wires to one wire.

E10 E11 E12 E13 E14 E15

PROBLEMS:

SOLUTION:

EXISTING METHODS:

SEALED MULTIPLE WIRE CONNECTORS:

IN-LINE CONNECTOR

Color dash on tubing indicates the wire gauge for the connector

QUICK-TAP

3-WAY CONNECTOR

ADDING WIRE

Color stripes on the connector indicate which crimp die to use

Tubing has an active adhesive that seals between multiple wires

UNSEALED CONNECTOR

Part No. 210600

Part No. 210601

Part No. 210602

Part No. 210603

White

Red

Blue

Yellow

PART COLOR STRIPE NUMBER QTY WIRE GAUGE TUBING COLOR

ON CONNECTOR

WIRE

CRIMP DIE (INSULATED) White (24-22 AWG) Red (20-18 AWG) Blue (16-14 AWG) Yellow (12-10 AWG)

(25) 24-22 AWG Clear / White Dashes Side 1: White

One 24-22 AWG One 20-18 AWG One 16-14 AWG One 12-10 AWG Two 24-22 AWG Red (20-18 AWG) Two 20-18 AWG Blue (16-14 AWG) Two 16-14 AWG Yellow (12-10 AWG) Side 1: Red Side 1: Blue Two 12-10 AWG Red (8 AWG)

210600

Side 2: Red Side 2: Blue Side 2: Yellow

(25) 20-18 AWG Clear / Red Dashes

210601

1 6-14 AWG Clear / Blue Dashes

210602

(25)

(25) 12-10 AWG Clear / Yellow Dashes Side 1: Yellow

210603

Side 2: Red

EASY TO INSTALL

2

1

3

4

CRIMP IT

STRIP WIRES & INSERT

HEAT IT

SEAL IT

1. For side of connector where two wires will be inserted, strip wires 5/8”. 2. Select a connector that matches the wire gauge (see chart above) and insert the two wires into the larger side of the connector. 3. Make sure that both wires are properly seated and crimp the connector using an insulated connector crimping tool nest that matches the color stripe on the larger side of the connector barrel. 4. For the side of the connector where one wire will be inserted, strip wire 5/16”. 5. Insert the wire into the smaller side of the connector, make sure the wire is properly seated and crimp the connector using an insulated connector crimping tool nest that matches the color stripe on the smaller side of the connector barrel. 6. Apply heat evenly around the length of the tubing (including the crimp area) from the center out to the ends until the tubing fully recovers and the adhesive flows. During the heating process, separate the two wires in the larger end of the connector to allow the adhesive to flow in between the wires. 7. Remove from the heat and let cool. IN-LINE BUTT CONNECTOR INSTRUCTIONS

E12-5 REVISED OCTOBER, 2018

© Copyright 2026. All rights reserved. No portion may be copied or reproduced in any manner.