Sosmetal Products, Inc. 2026 Product Catalog

SOSMETAL PRODUCTS INC.

CHEMICALS

PRODUCT SPECIFICATIONS & APPLICATIONS

Part No. NPL304 • MASTER CLEAN • Non-Flammable Cleaner/Degreaser • Products Specifications Ingedients: Perchloroethylene, Carbon Dioxide

FEATURES AND BENEFITS WORKS FAST: Cleans much faster than ordinary solvents. Dries instantly. No residue. POWERFUL CLEANING ACTION: Cuts through grease, oil, grime, tar, asphalt, wax, and adhesives. NON-CONDUCTIVE: High dielectric strength up to 40,000 volts (per ASTM D-87). NON-FLAMMABLE: No flash point. SAFE ON METALS AND MOST MATERIALS: Non-acid, non-caustic, non-corrosive. May be harmful to some plastics. Test on a small area before using. Will remove skin oils. Use of rubber gloves strongly recommended.

C11 C12 C13 C14 C15 C10 C16 C17 C18 C19 C20 C21

Appearance : Clear Colorless Liquid Odor: Lemon Odor pH: N/A Storage: Below 120°F (49°C) Boiling Point: 250°F

Vapor density: Above 1.0 Evaporation Rate: Not established Specific Gravity: (Water=1) 1.62 ∀ .05 Solubility in Water: Nil

APPLICATIONS AND USES CLEAN AND DEGREASE Air tools Machinery

Compressors

Mechanical brakes

Parts

Switch gear

Chains

Bearings

Presses

Wire rope

Motors

Park lights

Dies and molds

Generators

Gears

DIRECTIONS FOR USE USE ONLY IN WELL VENTILATED AREA. Simple to use. Spray on and wipe off dirt and grease. Or spray on and let dirt and grease flush off.

Part No. NPL313 • SHARK • Coil & Fin Cleaner •

FEATURES AND BENEFITS Spray on, walk away, no rinse needed. Wait for a few minutes and watch the foam condense and wash away dirt, dust and grime. Non-corrosive, non-acid formula cleans both condenser and evaporator coils leaving pleasant odor to freshen entire room.

Products Specifications

Ingedients: Water, Ethylene Glycol Monobutyl Ether, Liquefied Petroleum Gas, Isopropyl Alcohol, D-Limonene, Ammonia

Vapor density: Above 1.0 Evaporation Rate: Slow to medium Specific Gravity: (water=1) Approximately .92 ∀ .05 Solubility in Water: Soluble

Appearance: Clear Colorless Liquid Odor: Citrus odor pH: N/A Storage: Below 120°F (49°C)

APPLICATIONS AND USES • Air conditioners • Refrigeration units • Icemakers

• Cooling towers • Heat pumps • Heat exchange equipment

• Zoneline® heat pumps • Condensation coolers

DIRECTIONS FOR USE Shake well. Spray coils and fins in a sweeping motion, starting at the top of the coil, flushing dirt to the bottom. For heavy dirt accumulations, spray lightly first, allow solvents to penetrate. Then, flush off. Repeat until all build up is removed. Safe to use on most washable surfaces. If in doubt, pretest on a small area.

Boiling Point: <0°F - >250°F

Part No. NPL316 • ZAP • Battery Cleaner & Protective Coating •

FEATURES AND BENEFITS • Eliminates corrosion. • Penetrates, dissolves and neutralizes corrosion and acid build-up on all storage batteries.

Products Specifications

Ingedients: Liquefied Petroleum Gas, Hydrotreated Light

• Leaves protective seal against future corrosion build-up. • Increases electrical conductivity and prolongs battery life.

Naphthenic Distillate, Hydrotreated Heavy Naphthenic Distillate, Heavy Paraffinic Distillate Solvent Extract, Lithium Complex Grease, Triethanolamine

Appearance : Red Grease Like Transparent Odor: Solvent odor pH: N/A Storage: Below 120°F (49°C)

Vapor density: Above 1.0 Evaporation Rate: Residual Film will not evaporate Specific Gravity: (water=1) Approximately .76 ∀ .05 Solubility in Water: Negligible

DIRECTIONS FOR USE SHAKE WELL BEFORE USING. Spray on battery terminals and attachments. Wait 2 to 3 minutes for it to loosen and dissolve corrosion deposits, then wipe clean with dry cloth. Spray a second light coat on all cleaned areas to guard against future deposit buildup.

Boiling Point: <0°F - >400°F

Part No. NPL319 • MAGIC • Instant Carpet Spotter •

FEATURES AND BENEFITS Thick foam lifts out and holds dirt and grime in suspension until vacuumed away. Use on spills right away, helps avoid hard-to remove stains later. Saves time and labor of cleaning spots.

Products Specifications

Ingedients: Deionized Water, 2-Butoxyethanol, Anionic Surfactant, Isobutane, Chelating Agent

Appearance : White Foam Odor: Mint odor pH: 12.75 + 0.5 Storage: Below 120°F (49°C)

Vapor density: Heavier than air

APPLICATIONS AND USES For use in hotels, corridors, walk-off entrance mats, automobile interiors, shops, all-natural or synthetic upholstery, velour rugs, and fabric.

Evaporation Rate: Slower than Ether Specific Gravity: (water=1) 0.80 + 0.05 Solubility in Water: Soluble

DIRECTIONS FOR USE Shake well before using. Vacuum carpet thoroughly. Invert and spray from 24 inches. With sweeping motion, cover area of about 4 square feet. With wet sponge mop or deck brush, work into carpet first across and then with nap. Repeat for all other areas. Let dry for at least 4 hours and then vacuum thoroughly. Wipe away overspray from walls and furniture before foam dries. Cover legs and casters to prevent rust spotting on carpet.

Boiling Point: <0°F - >212°F

C15-7 REVISED JULY, 2015

© Copyright 2026. All rights reserved. No portion may be copied or reproduced in any manner.